ProForm 790tr Treadmill Uk Manual - Page 7
the inset drawings. IF THE CONNECTORS ARE
View all ProForm 790tr Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. With the help of a second person, carefully tip the Upright Base (97) down as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [92] as you tip the Upright Base.) Make sure that the Extension Legs remain in the Upright Base. Attach each Extension Leg (92) with two Extension Leg Bolts (96) and two 1/4" Washers (39) as shown. Next, thread a Levelling Foot (95) into each side of the Upright Base (97); do not thread the Levelling Feet fully into the Upright Base. Attach the two Base Pads (99) to the Upright Base (97) in the locations shown with two 1" Tek Screws (135). With the help of a second person, raise the Upright Base (97) to the vertical position. 2 99 135 39 97 92 39 96 97 95 92 39 96 3. Attach the Latch Assembly (82) to the Left Upright (84) with the two Latch Screws (134). Start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the Left Upright. 3 134 84 82 99 135 96 95 96 4. See step 6 and locate the four Upright Bolts (86). Loosen the Upright Bolts two to three turns. See drawing 4c. With the help of a second person, hold the Console Base (101) near the Uprights (80, 84). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (109, 111). Drawing 4a shows the correct route for the wires. Drawing 4b shows an incorrect route. See drawing 4c. Cut the plastic ties holding the Wire Harness (74) and the Pulse Wire (153) in the Uprights (80, 84). Connect the Wire Harness and the Pulse Wire to the wires on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. Insert the excess Wire Harness and Pulse Wire up into the Console Base. 4a Correct 4c 111 75 80 74 7 4b Incorrect 101 109 81 84 153