ProForm 790tr Treadmill Uk Manual - Page 8

5. Set the Console Base (101) on the Uprights (80, 84). 5 Attach the Console Base to the each Upright with two Console Bolts (76) and two Internal Star Washers (77). Be careful not to pinch the Wires (not shown) in the Uprights. Note: Start all four Console Bolts before tight- ening any of them. Make sure that the Left and Right Trays (109, 111) are pressed into the Console Base (101). 76 6. Press a CD Holder (85) into each side of the Upright Base 6 (97). If the Wheels (not shown) are touching the floor, or if the treadmill rocks slightly, see HOW TO LEVEL THE TREADMILL on page 26. 86 If you wish to adjust the height of the Uprights (80, 84), go to step 7. If the Uprights are at the desired height, tighten the four Upright Bolts (86) and go to step 8. 101 111 109 77 80 77 76 77 84 84 85 85 97 80 97 86 7. Note: The Uprights (80, 84) can be attached at three different heights. The Uprights are preattached in the mid- 7 dle position. Adjusting the Uprights requires two persons. Whilst a second person holds the Console Base (101) and the Uprights (80, 84), loosen the four Upright Bolts (86). Then, remove the two Upright Bolts and Upright Star Washers (127) from the Right Upright (80). Raise or lower the Right Upright to the desired height, being careful not to damage the Wire Harness (74). If the Upright Spacer (79) falls, press it back onto the Upright Base (97). Loosely thread the two Upright Bolts and Upright Star Washers back into the Right Upright and the Upright Base. Adjust the Left Upright (84) in the same way. (Note: There is not a wire harness in the Left Upright.) Make sure that both Uprights are at the same height. Lift the Walking Platform (13) to make sure that it is centred between the Uprights. Retighten all four Upright Bolts (86). 84 127 86 13 101 79 80 74 79 127 97 86 8. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking belt (see page 30). To protect the floor or carpet, place a mat under the treadmill. If there are thin sheets of clear plastic on the decals, remove them. 8