ProForm 980 Cs Treadmill English Manual - Page 9
Console May Be Damaged When
View all ProForm 980 Cs Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Set the console assembly face down on a soft 7 surface to avoid scratching the console assem- bly. Console Wire Hold the Right Handrail (95) near the console Hole 1 assembly. Next, insert the console wire into the 95 large hole in the Right Handrail and out of the 1 top as shown. If necessary, use needlenose pli- ers to pull the console wire out. Attach the Right Handrail (95) and the Left Handrail (not shown) with four #8 x 3/4" Screws (1) (only two are shown). Make sure that no wires are pinched. Start all four Screws before tightening any of them; do not overtighten the Screws. Console Assembly 8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star 8 Washer (33) into the Handrail Crossbar (94) and the bracket on each side of the console assembly (only one side is shown). Remove the wire tie from the console wire. Console Wire Wire Tie 5 33 Console Assembly 9. Remove the tie from the Cage Nut (88). Have a second person hold the console assembly near the Right Upright (78) and the Left Upright (not shown). Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, remove the long tie from the Upright Wire. Set the console assembly on the Right Upright (78) and the Left Upright (not shown). Be careful not to pinch the wires. 9 Console Assembly Console Wire 38 78 94 88 Long Tie Console Wire 38 9