ProForm 990 Cs Treadmill English Manual - Page 11

9. Hold the Right Handrail (79) near the Right Upright (83). Insert the Upright Wire (85) 9 through the Right Handrail as shown. Slide a Handrail Cover (77) onto the lower end of the Right Handrail. Remove the tie from the bracket on the Right Handrail. If necessary, press the Cage Nut (27) back into place. Insert the bracket on the Right Handrail (79) into the top of the Right Upright (83) and at the same time slide the lower end of the Right Handrail onto the bracket on the Right Upright. Start two 5/16" x 3/4" Screws (5) with two 5/16" Star Washers (9) into the Right Upright (83) and the Right Handrail (79). Then, start a 5/16" x 1 1/2" Bolt (4). Do not tighten the Screws and Bolt yet. Be careful not to pinch the Upright Wire (85). Start a 1/4" x 1/2" Screw (8) into the lower end of the Right Handrail (79). Tighten the Bolt and all three Screws used in this step. Slide the Handrail Cover (77) against the Right Upright (83). 85 59 79 8 27 Bracket 4 83 Bracket 77 10. With the help of a second person, hold the console assembly near the Right Handrail (79) and the Left Handrail (not shown). Connect the Upright Wire (85) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire. 10 Console Assembly 79 Wire Tie Console 85 Wire Console Wire 85 11