ProForm Smart Strider 6.5 Elliptical English Manual - Page 23
HOW TO ADJUST THE REED SWITCH, press the power switch to the off posi, tion and unplug the power
View all ProForm Smart Strider 6.5 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first press the power switch to the off position and unplug the power cord. Next, remove the four M4 x 16mm 37 Screws (not shown) from the Large Storage 27 Foot (27), and then remove the Large Storage Foot. Then, remove the two M4 x 16mm Screws (not shown) from the Top Shield (37), and then use a standard screwdriver to pry the Top Shield upward off the elliptical. See the drawing at the right. Look into the access opening and locate the Reed Switch (58). Rotate the Pulley (66) until a Magnet (41) is aligned with the Reed Switch. 61 41 58 66 Next, slightly loosen the two indicated M4 x 16mm Screws (61), slide the Reed Switch (58) slightly toward or away from the Magnet (41), and then retighten the Screws. Plug in the power cord, press the power switch to the reset position, and rotate the pulley for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, press the power switch to the off position, unplug the power cord and reattach parts that you removed. Then, plug in the power cord. 23