ProForm Tdf 1.0 Instruction Manual - Page 25
Maintenance And Troubleshooting
View all ProForm Tdf 1.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
MAINTENANCE AND TROUBLESHOOTING HOW TO MAINTAIN THE EXERCISE BIKE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the exercise bike is used. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild detergent. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. Next, remove the four #8 x 1/2" Screws (95) and the Electronics Shield (98). Then, locate the Reed Switch (35), and loosen the two #8 x 19mm Tek Screws (97). 98 95 INCLINE SYSTEM TROUBLESHOOTING If the exercise bike does not move to the correct incline or decline level, see step 3 on page 24 and calibrate the incline system. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. 53 55 97 35 To adjust the reed switch, first press the power switch to the off position and unplug the power cord. Then, use a standard screwdriver to remove the Shield Cover (10) from the exercise bike. 10 Next, rotate the Crank Pulley (53) until a Pulley Magnet (55) is aligned with the Reed Switch (35). Slide the Reed Switch slightly toward or away from the Pulley Magnet. Then, retighten the #8 x 19mm Tek Screws (97). Plug in the power cord and press the power switch to the reset position. Rotate the Crank Pulley (53) for a moment. Repeat these actions, if necessary, until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the electronics shield and the shield cover. Then, plug in the power cord. 25