ProForm Tdf 1.0 Instruction Manual - Page 9

6. Loosen the Seat Knob (29), and then pull it downward. 6 Next, insert the Seat Carriage (4) into the Seat Post (3), and release the Seat Knob (29) into one of the adjustment holes in the Seat Carriage. Make sure that the Seat Knob is in an adjustment hole. Then, tighten the Seat Knob. See the inset drawing. Tighten a #8 x 6mm Screw (92) into the underside of the Seat Carriage (4). 4 3 29 4 92 7. Have a second person hold the Handlebar Post (6) near the Frame (2). Locate the long wire tie (B) in the Handlebar Post (6). Tie the lower end of the long wire tie to the Main Wire (68). Next, locate the middle of the long wire tie (B) in the access hole (C) in the Handlebar Carriage (105). In the indicated location (D), pull the long wire tie upward until the end of the Main Wire (68) is in the access hole. See the inset drawing. Next, pull the free end of the long wire tie until the Main Wire (68) is routed through the Handlebar Carriage (105) as shown. Then, untie and discard the long wire tie; do not remove the short wire tie. 7 D 105 B Avoid pinching C the Main Wire (68) 6 B 68 2 68 105 B 9