ProForm Xp210 U Bike English Manual - Page 10

9. Hold the Console Plate (19) near the Upright (3). Insert the Main Wire (31) upward through the 9 Console Plate. Next, insert the Console Plate (19) into the Upright (3), and align the indicated large holes. 31 19 Large Holes 3 10. Have a second person hold the Handlebar (47) near the Upright (3). 10 Locate the Pulse Wire (52) in the Handlebar (47). Insert the Pulse Wire into the large hole in the Upright (3), and then pull the Pulse Wire out of the top of the Console Plate (19). Attach the Handlebar (47) and the Console Plate (19) to the Upright (3) with two M8 x 25mm Screws (44) and two M8 Curved Washers (8). 47 52 8 44 19 3 11. The Console (6) can use four D batteries (not included); alkaline batteries are recommended. 11 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic com- ponents. Remove the screws and the battery covers from the back of the Console, and insert batteries into the battery compartments. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. Then, reattach the battery covers. To purchase an optional power adapter, call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power adapter. Plug one end of the power adapter into the receptacle inside the battery compartment on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. 10 Battery Cover 6 Battery Cover Receptacle