RCA BRC3073 BRC3073 Product Manual - Page 18
Maintenance - software update
View all RCA BRC3073 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
View Mode 16:9 Fill, 16:9 Pillarbox, 4:3 Fill, 4:3 Pan Scan, and 4:3 Letterbox are available for your choice. Note: Depending on the disc, you may not be able to view the mode as selected. HDMI Resolution To select the HDMI resolution to match the capabilities of your TV. Note: HDMI resolution can be only selected if the HDMI cable is connected to a TV. General Setup 1. In STOP mode, press the SETUP button. Press the button to select General. 2. Use the button to move the highlight bar to the right, use the or button to select Screen Saver, Software Update, Use Default Settings and BD-Data Storage, press the OK button to select. 3. Use the or button to select your settings, then press the OK button to confirm. 4. Press the button to go back to the previous menu. Repeat steps 2 and 3 to adjust other options. 5. To exit the SETUP MENU and return to the normal screen, press the EXIT or SETUP button. Screen Saver To turn on or off the screen saver (screen protection to prevent image burn). Note: • When you leave the unit in stop mode for approximately 5 minutes, the screen saver of the unit automatically appears if you set the Screen Saver to On mode. To turn off the screen saver, press the PLAY button. • When screen saver appears approximately 15 minutes, the unit will automatically turn to STANDBY mode. Press STANDBY/ON button (on the remote control) or Play/Pause button to turn the product from STANDBY mode to ON. Software Update For future Product Software Upgrades - please visit www.RCAav.com for information on updates. Use Default Settings Restores your player to the original factory settings. The unit will exit the default setting menu automatically and re-load the disc in the disc tray. Note: It will take 3-5 seconds to reset the player to the factory default. BD-Data Storage The available storage space is displayed next to BD-Data Storage. Maintenance Cleaning the Disc A defective or soiled disc inserted into the unit can cause sound to drop out during playback. Handle the disc by holding its inner and outer edges. • Do NOT touch the surface of the unlabeled side of the disc. • Do NOT stick paper or tape on the surface. • Do NOT expose the disc to direct sunlight or excessive heat. • Clean the disc before playback. Wipe the disc from the center outward with a cleaning cloth. • NEVER use solvents such as benzine or alcohol to clean the disc. • Do NOT use irregular shaped discs (example: 14 heart shaped, octagonal, etc.). They may cause malfunctions. Cleaning the Unit • Be sure to turn the unit off and disconnect the power source before maintaining the unit. • Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe with a dry cloth. • Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. Do NOT use compressed air to remove dust. Important Note • Before transporting the unit, remove any disc from the disc compartment.