Roku M2000 User Guide - Page 7

III. Hooking Up Your Home Network Hardware (Wired Ethernet or Wireless) Ethernet Connection Plug your cable into the jack provided on the right side of the rear of the unit. Connect your Ethernet cable to a hub, switch or router on your home network. Alternatively, you can connect SoundBridge directly to your computer (and bypass a hub/switch/router), but only with a "crossover" cable (sold separately). Connect the other end of the cable to your network. Wireless Connection No need to install any additional hardware into SoundBridge. Please note that most, but not all, wireless access points are compatible with SoundBridge. You can find a list of supported wireless hardware at www.rokulabs.com/support. IV. Hooking Up Your Speakers or Stereo System Connect your choice of audio cables into the back left side of SoundBridge depending on your preferred connection option. Audio cable connectors Digital Audio Outputs Optical Coax AC Adapter Connection Analog 1/8" Miniplug Wired Ethernet Network Connection 10 Section 1: Getting Started 1 Your SoundBridge has several audio connection options: a. Connect your SoundBridge to a set of powered speakers by inserting the 1/8" cable from your powered speakers into the Analog 1/8" Miniplug connector on SoundBridge. Note: If your speakers have a male connector, you will need a female-to-female coupler available from Radio Shack. b. Connect the RCA (red/white) audio cable included with your SoundBridge to your stereo system's Aux or other "Line Input" and connect the other end of this cable to SoundBridge's Analog 1/8" Miniplug connector. c. Connect to your stereo system using either coaxial SPDIF digital or optical SPDIF digital (the SoundBridge has connectors for both) - cables sold separately. Section 1: Getting Started 11