Samsung ME19R7041F Installation Guide - Page 13

Step-by-step installation guide 3. Remove the screw that holds the blower motor and carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. 7. Close the blower door. Slide blower shield onto the top of the blower door opening. CAUTION: To avoid breaking or cracking the blower blade, do not touch the blade. Hold the outer case of the blower when you pull it out or put it back in place. 4. Roll the blower unit 90 ° so that the fan blade openings are facing toward the front of the microwave. Before Roll After Roll 8. Secure the blower to the microwave using the blower retaining screws from Step 1. Blower Retaining Screw Blower Retaining Screws 5. Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6. Remove the metal vent fan cover on the back of the microwave by sliding it up. Back of Microwave Oven B2. INSTALLING THE CHARCOAL FILTER 1. Remove the screws on the top of the grille using a #1 Phillips screwdriver. 2. Open the door. 3. Remove the grille. • Push the grille left, and then pull the grille straight off. Charcoal filter 4. Install the charocal filter. When properly installed, the wire mesh of the filter should be visible from the front. 5. Reinstall the grille and the screws. 6. Close the door. Insert mesh-side up ME4000R_ME19R7041FS_AA_DE68-04585A-01_EN.indd 13 13 2021-03-25 오전 11:43:20