Samsung ME19R7041F Installation Guide - Page 14
C. Outside back exhaust (horizontal duct), C1. Adapting the microwave blower for outside back exhaust
View all Samsung ME19R7041F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step-by-step installation guide C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT) C1. ADAPTING THE MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST 1. Remove and save screw that holds blower Plate to microwave. Blower Retaining Screws Back of Microwave Oven 2. Open the blower door by lifting it up at the back of the microwave. Remove and save the blower shield on the back of the microwave by sliding it up. Remove and save the metal vent fan cover on the back of the microwave by sliding it up. 3. Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade Openings Facing Forward End B End A CAUTION: To avoid breaking or cracking the blower blade, do not touch the blade. Hold the outer case of the blower when you pull it out or put it back in place. 4. Remove Parts "A" with tin snips or pliers. Parts "A" 5. Rotate the blower unit counterclockwise 180 °. Before Rotation After Rotation Back of Microwave Back of Microwave 6. Place the blower unit back into the opening. AFTER: Fan Blade Openings Facing Back End A End B CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: The blower unit exhaust openings should match the exhaust openings on the rear of the microwave oven. 7. Close the blower door. Slide blower shield onto the top of the blower door opening. Secure the blower to the microwave oven using the blower retaining screws from Step 1 except the upper blower motor retaining screw. Blower Retaining Screw Blower Shield Blower Retaining Screw Back of Microwave Oven 8. Slide the exhaust adaptor onto the back of the microwave oven, securing it into the lower locking tabs. Take care to ensure that the damper hinge is installed so that it is at the top and that the damper swings freely. Reinstall the upper blower motor screw through the adaptor and the blower door and into the back of the microwave oven. Back of Microwave Oven Guide Adaptor Guide Locking Tabs (not shown) Blower Motor Door Retaining Screw ME4000R_ME19R7041FS_AA_DE68-04585A-01_EN.indd 14 14 2021-03-25 오전 11:43:20