Samsung ME19R7041F Installation Guide - Page 8

Step-by-step installation guide 1. PLACEMENT OF THE MOUNTING PLATE A. REMOVING THE MICROWAVE OVEN FROM THE CARTON/REMOVING THE MOUNTING PLATE 1. Remove the installation instructions, Exhaust adaptor, filters, glass tray, and the small hardware bag. Do not remove the Styrofoam protecting the front of the oven. 2. Fold back all 4 carton flaps fully against carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam. CCaarrtotnon StyroSftoyraofmoam 3. Pull the carton up and off the oven. 4. Remove and properly discard plastic bags. Screws Screws Mounting Plate B. FINDING THE WALL STUDS WWaallll SStuuddss CeCnetnetrer 1. Find the studs using one of the following methods: A. W ith a stud finder - a magnetic device which locates nails. OR B. U se a hammer to tap lightly across the mounting surface until you hear a solid sound. This will indicate a stud location. 2. After locating the stud(s), locate the stud's center by probing the wall with a small nail to find the edges of the stud. Then, place a mark halfway between the edges. The center of any adjacent studs should be 16˝ or 24˝ from this mark. 3. Draw a line down the center of the studs. THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD. 5. Remove the 2 screws from the mounting plate. This plate will be used as the rear wall template and for mounting. NOTE: Retain the two screws. You will need to re-insert the screws in their original locations after you have removed the mounting plate. 8 ME4000R_ME19R7041FS_AA_DE68-04585A-01_EN.indd 8 2021-03-25 오전 11:43:18