Samsung RB215BSSB Service Manual - Page 35
Defrost Function, 10 Test Function
View all Samsung RB215BSSB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Temp Control &Operation Functions 11-9) Defrost Function 1) The F/R-Room defrost depends on the accumulated comp-on time. 2) With the initial power on,defrost starts at the both rooms after 4 hour accumulated comp-on time. 3) The defrost cycle can be changed from Min 6 hours to Max 7 hours according to various conditions. 4) The defrost cycle depends on the ambient temperature,the frequency of F/R-Door open and the duration of the F/R-Door open. 5) The Defrost Heater Off temperatures are compared using the temperature values of R-Defrost Sensor and F-Defrost Sensor and they are as follows. R-Room F-Room E t c Defrost Start Lower than 50℉(10℃) Lower than 23℉(-5℃) Defrost Restoration Temp 62.6℉(17℃) 53.6℉(12℃) Note Defrost restoration temperatures could be changed without notice for the purpose of performance improvements. 11-10) Test Function �This function is for PCB,Product and Process Test, and SVC. �After checking the product functions by selecting Test S/W,turn on the power again. 1) Forced Operation Function Display for Forced Operation Display for Forced Operation and How to Turn it On ① (Press for 8 seconds simultaneously) + ② All LEDs Off, Press one of the following buttons (Super Freeze, Super Cool,Freezer, Fridge Key) 1-1) When the Super Cool button and the Fridge button on the display panel are pressed for 8 seconds simultaneously,the display panel will be shifted to the Test Setting Mode and all the LEDs will be off. 1-2) When any of Super Freeze,Super Cool,Freezer and Fridge buttons is pressed within 15 seconds with the display panel shifted to the Test Setting Mode, it will be selected in the order of Forced Operation → Forced R-Defrost → Forced F/R-Defrost → Cancel. 1-3) When there is no button press within 15 seconds after the display panel is shifted to the Test Setting Mode,it will go back to the previous display mode. 1-4) When the Test Setting Mode is selected or cancelled,it will send out a "BEEP"sound. 1-5) When Forced Operation is selected,the F-Room LED will display "FF"and the R-Room LED will display its real compartment temperature. But, when it passes more than a minute with Forced Operation selected,and then Forced Defrost or Test Cancellation is selected,the temperature setting will not be changed (maintaining -14 ℉and 34℉) When Forced Defrost or Test Cancellation is selected within a minute after Forced Operation is selected,the Notch will go back to the previous notch setting. 1-6) During Forced Operation,the Full-Down function will be maintained only for 24 hour s.Af t er t hat, it will go in to normal operation after carrying out F/R-Defrost automatically. 35