Samsung RS25H5000SR User Manual Ver.00 (English) - Page 16
Checking The Water, Dispenser Line, Installing The Water Line - lowes
View all Samsung RS25H5000SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
CHECKING THE WATER DISPENSER LINE A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) is required. Under normal conditions, a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds. If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. INSTALLING THE WATER LINE Connecting the water line to the Refrigerator. There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. • 1/4" compression nut • copper tubing • plastic tubing • ferrule Refrigerator Compression Nut (1/4") (Assembled) Plastic Tubing (Supplied) Compression Fitting (Assembled) Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing. Ferrule (Not supplied) Bulb (B) Compression nut (B) (1/4") (Not supplied) Copper tubing or Plastic tubing (B) (Not supplied) (Not supplied) Connecting to the water supply line 1. First, shut off the main water supply line and turn the ice-maker off. 2. Locate the nearest cold, drinking water line. 3. After connecting the water supply to the water filter, turn your main water supply back on and flush 3 gallons (Flush approximately 6 minutes) into a bucket to clear and prime the water filter. Cold water line Pipe clamp Shut off valve Water line installation kit Household water line 1. Tighten the compression nut ( B ) into the 1/4" compression fitting. -- If you are using copper tubing, slip the compression nut ( B ) (not included) and ferrule (not included) on copper tubing (not included) as shown. -- If you are using plastic tubing ( B ), insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting. CAUTION Do not use without the molded end (Bulb) of the plastic tubing ( B ). SSEDA-14 (RS25H5121) ���.indd 16 English - 16 2013. 11. 28. �� 11:28