Samsung RS25H5000SR User Manual Ver.00 (English) - Page 17

When using power cord., Removing residual matter inside the water, supply line after installing - water filter

Get Samsung RS25H5000SR PDF manuals and user guides View all Samsung RS25H5000SR manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

01 setting up 2. Tighten the compression nut ( B ) into the compression fitting. Do not over-tighten the compression nut ( B ). Removing residual matter inside the water supply line after installing filter 3. Turn water on and check for any leakage. Only connect the water line to a drinkable Ice water source. If you have to repair or disassemble the water line, cut off 1/4" of the plastic tubing to make sure you get a snug, leak-free connection. Water When using power cord. To prevent power cord damage, arrange the remaining power cord on top of refrigeration rear LOCK and fix. Non operation 1. Turn ON the main water supply. 2. Press the Water button and push the dispenser pad. LOCK 3. Flush 3 gallons of water through the filter before use. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines. 4. Additional flushing may be required in some households. 5. Open the refrigerator door and make sure there are no water leaks coming from the water filter. A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation. SSEDA-14 (RS25H5121) ���.indd 17 English - 17 2013. 11. 28. �� 11:28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
English - 17
01 SETTING UP
2. Tighten the compression nut ( 
B
 ) into the
compression fitting. Do not over-tighten the
compression nut ( 
B
 ).
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4” of the plastic tubing
to make sure you get a snug, leak-free
connection.
When using power cord.
To prevent power cord damage, arrange the
remaining power cord on top of refrigeration rear
and fix.
Non operation
Removing residual matter inside the water
supply line after installing filter
Water
Ice
LOCK
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser
pad.
3. Flush 3 gallons of water through the filter before
use. (Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is due to air getting into the line.
It should pose no problem to operation.
SSEDA-14 (RS25H5121) ���.indd
17
2013. 11. 28.
�� 11:28