Samsung RS27FDBTNSR User Manual Ver.0.2 (English, French, Spanish) - Page 95
How To Replace The Water, Filter
View all Samsung RS27FDBTNSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
02 operating • Not dispensing ice for long periods may cause ice clumps in the ice bucket. -- Lift up and pull out the ice bucket to discard remaining clumps. -- When replacing the bucket, be sure to press it firmly into place. HOW TO REPLACE THE WATER FILTER What Does the Water Filter Do? The water filter filters out impurities that may be in tap water including pathogens, insecticides, organic compounds, and mercury. It also filters out excess chlorine, removing the taste and smell of chlorine from the water. Filtrate and Purifying Effect -- The filtrate in the water filter is made of activated charcoal. -- The filter is NSF (National Science Foundation) certified, and meets the standard requirements for food safety and filter effectiveness listed in NSF 42 and 53. See the table below. Certification Standard NSF 42 NSF 53 Remove Capacity Smell, Chloride Pathogens, insecticide, asbestos, slime, benzol, organic compounds, mercury • When to Replace the Filter -- - When the Filter Status Indicator on the display turns from blue to pink, it is time to replace the filter. If the Indicator turns from pink to red, replace the filter immediately. -- You can purchase a replacement filter from your nearest authorized Samsung service center, authorized Samsung retailer, or on line at www. samsungparts.com. How To Replace Water-Purifying Filter To reduce the risk of water damage WARNING to your property DO NOT use generic brands of water filers in your SAMSUNG Refrigerator. USE ONLY SAMSUNG BRAND WATER FILTERS. SAMSUNG will not be legally responsible for any damage, including, but not limited to property damage caused by water leakage from use of a generic water filter. SAMSUNG Refrigerators are designed to work ONLY WITH SAMSUNG Water Filter. 1. Remove the old water filter. -- Open the unit grill in the upper part of refrigerator, rotate the filter 90° to the left to unlock it, and then pull it down. Place a bucket or bowl a little bit bigger than the filter under the filter to catch any water that drips when you separate the filter from the refrigerator. 2. Unpack the new filter, and then peel off the red protective cap. 3. Put an installation date sticker on the new filter. Example) If installing it in October, put on the `OCT 10' sticker. 4. Install the new filter. -- Insert the filter into the filter holder and then rotate it 90° to the right to lock it. Make sure to line up the the indicator line ( ) with Lock ( ) sign. -- Close the unit grill, and then press the ice-maker test button to check if water flows out. -- We recommend you dispense water for about 2 minutes (2 quarts or 2 liters) when you Unlock install or replace a filter to flush the water line. -- After replacing the filter, touch and hold 'Replace' on the upper right side of the Water Filter screen for 3 or more seconds Lock to reset the water filter indicator. See page 80 and 81 for details. DA68-02935A-02.indb 95 operating _95 13. 8. 28. �� 9:11