Samsung SMH1816B Installation Instructions - Page 13
Installing The Charcoal, Filter - charcoal filter
View all Samsung SMH1816B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Step-by-step installation guide 3. Remove the screw that holds the blower motor and carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. 5. Place the blower unit back into the opening. vented blower mortor screw CAUTION: To avoid breaking or cracking the blower blade, do not touch the blade. Hold the outer case of the blower when you pull it out or put it back in place. 4. Roll the blower unit 90 ° so that the fan blade openings are facing toward the front of the microwave. Before Roll CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6. Secure the blower unit to the microwave with the screw. B2. Installing the charcoal filter 1. Remove the screws on the top of the grill using a #1 Phillips screwdriver. 2. Open the door. 3. Remove the grill. • Push the grill left, and then pull the grill straight off. Charcoal filter Back of Microwave After Roll Back of Microwave 4. Install the charocal filter. When properly installed, the wire mesh of the filter should be visible from the front. 5. Reinstall the grille and the screws. 6. Close the door. Insert mesh-side up 13 SMH1816_XAA-DE68-03943A-02-EN_120725.indd 13 2012-07-25 �� 7:49:17