Samsung SMH1816B Installation Instructions - Page 8

Step-by-step installation guide 1. Placement of the mounting plate C A. Removing the B. Finding the wall studs P microwave oven from the carton/Removing the mounting plate 1. Remove the installation instructions, Exhaust adaptor, filters, glass tray, and the small hardware bag. Do not remove the Styrofoam protecting the front of the oven. WWaallllSStutdusds CCeenntetrer 2. Fold back all 4 carton flaps fully against carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam. 1. Find the studs using one of the following methods: CCaarrtotonn A. Stud finder-a magnetic device which locates nails. SSttyyrorofofoaamm OR PP B. Use a hammer to tap lightly across the fc mounting surface to find a solid sound. This will indicate a stud location. 3. Pull the carton up and off the oven. 4. Remove and properly discard plastic bags. 2. After locating the stud(s), find the stud's center by probing the wall with a small nail to find the edges of the stud. Then, place a mark halfway between the edges. The center of any adjacent studs should be 16˝ or 24˝ from this mark. SSccrreewwss SSccrreewwss MMoounnttininggPPlatlae te 3. Draw a line down the center of the studs. THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD. 5. Remove the 2 screws from the mounting plate. This plate will be used as the rear wall template and for mounting. NOTE: You will have to reuse two screws in original loction of outcase after removing mounting plate. 8 SMH1816_XAA-DE68-03943A-02-EN_120725.indd 8 2012-07-25 �� 7:49:14