Samsung SPL4225 User Manual (user Manual) (ver.1.0) (English) - Page 9

4 Remove four large screws from the rear side of the display. 5 Insert the bolts and insulation sinto the four screwholes as shown in the following figure: Œ Bolt ´ Insulation holder 6 Put the insulation rubber point protruding from the rear top of the display in the groove on the top of the wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the bottom of the rear side of the display is put in the groove at the bottom of the wall attachment panel. (Do not lift the display with any pressure. The insulation rubber at the top may be taken off. ) Œ ´ 16 Separating the Display from the Wall Attachment Panel Remove the fixing bolts from both sides (left and right) of the wall attachment panel. Lift and pull the bottom of the display a small amount, to separate the insulation holder point from the bottom of the wall attachment panel. Lift the display and separate the insulation holder point from the groove on top of the wall attachment panel. Œ ´ 17