Samsung WF56H9100AG/A2 User Manual Ver.0 (English, French, Spanish) - Page 21

03 washing a load of laundry 6 Select Cycle Option 7 Start/Pause selection button 8 Power button Press these buttons to select different cycle options. Pre Wash - To use this feature, add detergent to the pre wash section of the detergent compartment. When turned on, the washer fills with cold water and detergent, tumbles, then drains and advances to the selected wash cycle. Some cycles cannot be selected with this option. (See page 37.) Extra Rinse - Add an additional rinse at the end of the cycle to remove laundry additives and perfumes more thoroughly. Extra Spin - Add additional time to remove more water from loads. Steam - Press this button to use the Steam Wash function. Steam Wash is available with the Normal, Heavy Duty, Bedding, Sanitize, Deep Steam, Whites and Allergen cycles. For heavily soiled, colorfast garments, Steam Wash improves stain treatment and uses less water. (See page 25.) My Cycle - Choose your favorite cycle including temperature, spin, soil level, options, etc. (see page 23.) Delay End - Any cycle can be delayed for up to 24 hours in one-hour increments. Displayed hour indicates the time at which the wash will be started. (See page 22.) Self Clean+ - Use to clean dirt and possible mold from the drum. Regular use (after every 40 washes) is recommended. No detergent or bleach is needed. (see page 31.) Super Speed - Press this button if you need to shorten the washing time, applicable for Normal, Heavy Duty, Deep Steam, Bedding or Allergen cycles. The shortened time may differ depending on the Cycle/Load/Option. Press to pause and restart cycles. Press once to turn your washer on, press again to turn your washer off. If the washer is left on for more than 10 minutes without any buttons being pressed, the power automatically turns off. Child Lock Child Lock prevents children from playing with your washer. Once you have activated the Child Lock function, the control panel cannot be activated, preventing children from playing with the washer. Activating the Child Lock function Press and hold both the Soil Level and Spin buttons simultaneously for approximately 3 seconds. • When you activate the Child Lock function, the door locks and the "Child Lock " lamp illuminates. • If you press the START/PAUSE button after you have activated the Child Lock function, none of the buttons will work except for the POWER button. • If you press a button when the buttons are locked, the "Child Lock " lamp blinks. Pausing the Child Lock function When the door is locked or the buttons are locked by the Child Lock function, you can pause the Child Lock operation for 1 minute by pressing and holding both the Soil Level and Spin buttons simultaneously for approximately 3 seconds. • If you pause the Child Lock mode temporarily, the door lock is released for 1 minute for user convenience. During this period, the "Child Lock " lamp blinks. • If you open the door after the minute is over, an alarm sounds for up to 2 minutes. • If you close the door within the 2 minutes, the door is locked and the Child Lock function is reactivated. If you close the door after the 2 minutes, the door is not locked automatically and no alarm sounds. English _21 64&3 8 JOEE