Schwinn 450 Elliptical Assembly and Owner's Manual - Page 32
Power-Up / Idle Mode, Auto Shut-Off Sleep Mode
View all Schwinn 450 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
To release the Incline Assembly: Do not adjust the workout angle when on the machine. 1. Grasp the Incline Handle and be prepared to support the weight of the raised parts of the machine. When released, the Incline Assembly may fully disengage. Make sure that you are able to support the weight of the raised parts of the machine safely. 2. With your foot, step and hold down one of the Incline Release Pedals. This releases the Incline Assembly. Note: The Incline Handle may need to be slightly lifted to disengage the Incline Assembly. 3. Lower to the desired height. In order to avoid possible serious injury when lowering the Rails, be careful to avoid fingers or hands being caught or pinched. 4. Step off the Incline Release Pedal. 5. Push down on the Pedals to be sure the Rails are secured by the Incline Assembly. Note: Do not step onto the machine until you know the Incline Assembly is secure. Power-Up / Idle Mode The Console will enter Power-Up / Idle Mode if it is plugged into a power source, any button is pushed, or if it receives a signal from the RPM sensor as a result of pedaling the machine. Auto Shut-Off (Sleep Mode) If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while in Sleep Mode. Note: The Console does not have an On/Off switch. 32