Sharp 37D7U LC-26D7U LC-32D7U LC-37D7U Operation Manual - Page 35

Watching TV Changing channels-Air/Cable You can change channels in several ways by pressing AIR or CABLE to select the antenna and then following one of the methods below . Method 1 Using CHr/s on the remote control unit or on the TV. Method 2 1. Press FLASHBACK to switch to the previously tuned channel. 2. Press FLASHBACK again to switch back to the currently tuned channel. NOTE • FLASHBACK will not work if no channel has been changed after TV is turned on. Method 4 1. Press INPUT. 2. Press a/b to select CableBox [TV], and then press ENTER. INPUT SOURCE TV CableBox [TV] INPUT1 INPUT2 INPUT3 INPUT4 INPUT5 i.LINK 3. Press CHr/s to change the channel of the cable box. Method 3 Using remote control buttons (0-9, • (DOT) to select channels for VHF/UHF/CATV/DIGITAL. To select a 1 or 2-digit channel number (e. g., Channel 5): Press 5s ENT Air 5 Air ANALOG 5 NOTE • When selecting a 1-digit channel number, it is not necessary to press 0 before the number. • When you enter 0-9 only, channel selection will be made if there is no operation for a few seconds. To select a 3-digit channel number (e. g., Channel 115): Press 1s1s5 Cable 1 Cable 11 Cable ANALOG 115 To select a 4-digit channel number (e. g., Channel 22.1): Press 2 s2s• (DOT) s1s ENT Air 2 Air 22 Air 22 . Air 22 . 1 Air DIGITAL 22 . 1 NOTE • When you enter 0-9 only, channel selection will be made if there is no operation for a few seconds. • If you push "0" by itself, nothing will happen. • Complete the above steps within a few seconds. • When you enter 0-9 and • (DOT), channel selection will be made if there is no operation for a few seconds. 34