Sharp MX-M450NA Administration Guide - Page 19
Disabling deletion of job programs
View all Sharp MX-M450NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Initial margin shift setting This setting is used to set the initial margin shift amount. The initial margin shift amount can be set from 0 mm to 20 mm (0" to 1") in increments of 1 mm (1/8"). Normally the margin shift is set to 10 mm (1/2") for both the front and back of the paper. Erase width adjustment This setting is used to set the initial width of edge erase copying. The edge erase width can be set from 0 mm to 20 mm (0" to 1") in increments of 1 mm (1/8"). The edge erase and centre erase widths are normally set to 10 mm (1/2"). Card shot settings This setting is used to set the initial original size for the card shot function. Enter the X dimension (width) first and then the Y dimension (length). Both the X and Y dimensions can be set from 25 mm to 210 mm (1" to 8-1/2") in increments of 1 mm (1/8"). Setting a maximum number of copies This setting is used to set the maximum number of copies that are allowed per original. Any number from 1 to 999 can be set for the maximum. The maximum number of copies is initially set to 999. Disabling deletion of job programs This setting is used to prohibit the deletion and changing of copy settings stored in job programs. Disabling of bypass-tray in duplex copy This setting is used to disable the use of the bypass tray when making duplex copies. The bypass tray is often used to feed label sheets, transparency film, and other special papers for which two-sided copying is prohibited. If one of these special papers enters the reversing unit, a misfeed or damage to the unit may result. If special media for which two-sided copying is prohibited is often used, it is recommended that you enable this setting. Disabling of auto paper selection This setting is used to disable the auto paper selection function. When this setting is enabled, paper that is the same size as the original placed on the document glass or in the automatic document feeder is not automatically selected. COPY SETTINGS 17