Sharp MX-M450NA Operation Manual - Page 152

INTERRUPTING A COPY RUN The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job. 1 Touch the [INTERRUPT] key. INTERRUPT RIGINAL 81/2x11 AUTO ORIGINA AUTO EXPOSUR AUTO 8x If interrupt copying is possible during a copy run, the [INTERRUPT] key will appear. (If the key does not appear, interrupt copying is not possible.) CANCEL ORIGINAL 81/2x11 0 AUTO EXPOSURE When the [INTERRUPT] key is touched in step 1, the [INTERRUPT] key AUTO 81/2x11 EXPOSURE AUTO 81/2x11 PAPER SELECT will be replaced by the [CANCEL] key as shown in the illustration. 100% To cancel an interrupt copy job while the interrupt original is being scanned or while you are selecting copy settings, touch the [CANCEL] key. 2 Place the original for the interrupt copy job in the document feeder or on the document glass (page 4-3). 3 Select the exposure mode, paper size, number of copies, and any other copy settings as needed, and then press the [START] key. NOTES ● If you touch the [INTERRUPT] key when auditing mode is enabled, the display will prompt you to enter your account number. Enter your account number with the numeric keys. The copies you make will be added to the count of the entered account number. ● If a copy is being printed when the [INTERRUPT] key is pressed, interrupt mode will begin after the copy is finished. ● If the document glass is used for an interrupt copy job, two-sided copying, sort copying, and staple sort copying cannot be selected. If any of these functions are necessary, use the document feeder. 4 The previous copy job automatically resumes after the interrupt job finishes. 5-44