Sharp PG-M25X PGM25X Operation Manual - Page 121
The VOLUME buttons
View all Sharp PG-M25X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Problem The power cannot be turned on or off using the POWER button on the projector. The screen turns green when using the INPUT 1 component. The screen turn pink when using the INPUT 1 RGB mode. The card installed in the INPUT 4 terminal cannot be recognized. "Not supported" is displayed. Picture is dark Picture is too bright and whitish The VOLUME buttons on the projector do not work Check • The key lock level is set. • If level B has been set, none of the buttons will work. If level A has been set, only Input Switch, Volume and AV mute will work. • The input signal type is not correctly set. • The input signal type is not correctly set. • Make sure that the card is installed. • Make sure that the Link indicator on the wireless LAN PC card is lit. • Is the card installed in the projector compatible with the projector? • Is the wireless LAN PC card installed in the projector different from the wireless LAN PC card AN-WC11B? • The LAMP REPLACEMENT indicator is blinking in red. Replace the lamp. • "Monitor Out" is set to "Disable" when the RGB monitor loop-out adaptor is connected to Monitor Out. • "Monitor Out" is set to "Yes (Y Cable)" when the RGB monitor loop-out adaptor is not connected to Monitor Out. • Picture adjustments are incorrectly set. The VOLUME buttons do not work when: (try the VOL+/- on the remote control) • when the menu is displayed • when the lens menu is displayed • when Pict in Pict is working • during Enlarge (More than double size) • a dot by dot screen resolution larger the panel resolution. Page 99 60 60 31 3 20 110 96 96 59 - Appendix PG-M25X#E#p116_125.p65 117 02.4.29, 3:27 PM -117