Sharp PN-V600 Operation Manual - Page 21
Remote Control Mode
View all Sharp PN-V600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Remote Control Mode With the remote control unit it's possible to perform operation of... • The primary monitor • Monitors with a specified ID No. • All primary/secondary monitors It's necessary to specify which type of operation will be performed in advance. 1. If using the remote control unit, press MODE for approx 5 seconds. If using the monitor buttons, hold both and at the same time on the primary. REMOTE CONTROL MODE ▲ ▲ MODE THIS MONITOR ONLY Operate this monitor. ALL MONITORS Performs operation of all primary/secondary monitors. * ALL will be displayed on the menu of the primary. * When it receives signals from the remote control unit, "Operating all monitors." will be displayed on the secondary screen. (Excluding power and input mode selection operation) * Settings may not be reflected depending on the state of the connected monitors. [Example] If the power for the primary is turned ON, the power for all the monitors will be turned ON. Secondary ID No.: 2 Power ON Primary ID No.: 1 Power ON Secondary ID No.: 3 Power ON Secondary ID No.: 4 Power ON POWER Press to turn the power ON OK CANCEL 2. Press or settings. , select the mode, then perform THIS MONITOR ONLY Performs operation of only the primary using the remote control unit. [Example] If the volume is lowered, the volume of the primary will lower. Secondary ID No.: 2 Primary ID No.: 1 VOLUME 10 Secondary ID No.: 3 Secondary ID No.: 4 Press to lower the volume SPECIFIED MONITOR Performs operation of a monitor with a specified ID No. using the remote control unit. Press or to select ID No., then press or to select the ID No. of the monitor that you will operate. * When it receives signals from the remote control unit, "Operating specified monitor." will be displayed on the primary screen. [Example.] If ID No. is set to 3 and the volume is lowered, the volume of the monitor for ID No.: 3 will lower. Secondary ID No.: 2 Primary ID No.: 1 Secondary ID No.: 3 VOLUME 10 Secondary ID No.: 4 Press to lower the volume When you would like to confirm the ID No. that is set to the monitor, press or to select ID No. DISPLAY, then press . The ID No. will be displayed on the screen. Press or to select EXPAND ITEM, and press or to select to perform this action or not. OFF For all monitors, only power, input mode selection, and product information display operations will be recognized. ON For all monitors, all operations will be recognized. After returning to the normal screen with procedure 3, when 5 minutes have passed from the end of operation, it will automatically return to OFF. ALL [EXPAND ITEM] will be displayed on the menu of the primary. * Even when REMOTE CONTROL MODE is set to ALL MONITORS, certain settings such as LAN settings and ID No. settings will not be reflected on the other monitors. 3. Press or to select OK, then press MENU and return to the normal screen. 4. Perform operation. Caution • When the remote control mode is set to ALL MONITORS and EXPAND ITEM is set to ON, performing remote control operations that change adjustment values will result in the secondary adjustment values being the same as the primary adjustment values. Secondary ID No.: 2 VOLUME 12 Primary ID No.: 1 VOLUME 11 Secondary ID No.: 2 VOLUME 10 Primary ID No.: 1 VOLUME 10 Secondary ID No.: 3 VOLUME 9 Secondary ID No.: 4 VOLUME 10 Secondary ID No.: 3 VOLUME 10 Secondary ID No.: 4 VOLUME 10 Press to lower the volume Be careful of this when adjusting individual displays. TIPS • You can copy the setting values of the primary to other monitors with COPY SETTING VALUE. (See page 25.) • The buttons on the monitor itself (primary) are also effective in remote control mode. • When monitors connected in a daisy chain are in standby mode for LOW POWER, operation cannot be performed for subsequent monitors. 21 E