Singer 1304 START Instruction Manual - Page 30

Inserting the Bobbin

Get Singer 1304 START PDF manuals and user guides View all Singer 1304 START manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

EN Inserting the Bobbin When inserting or removing the bobbin, the needle must be fully raised, to the highest position. a - Remove the extension table, then open the hinged cover. (1) - Pull the bobbin case tab (a) and remove the bobbin case. (2) - Hold the bobbin case with one hand. Insert the bobbin so that the thread runs in a clockwise direction (arrow). (3) - Pull the thread through the slit and under the finger, while holding the bobbin down in the case until thread clicks into place (4). Leave a 6 inch tail of thread. - Hold the bobbin case by the open hinged latch. (5) - Insert the bobbin case into the shuttle, so that the bobbin case finger is aligned at 12 o'clock. (6) Attention: Turn power switch to off ("O") before inserting or removing the bobbin. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
When inserting or removing the bobbin, the needle must
be fully raised, to the highest position.
Attention:
- Remove the extension table, then open the hinged cover. (1)
-
Pull the bobbin case tab (a) and remove the bobbin case. (2)
- Hold the bobbin case with one hand. Insert the bobbin so
that the thread runs in a clockwise direction (arrow). (3)
- Pull the thread through the slit and under the finger,
(4)
Leave a 6 inch tail of thread.
-
Hold the bobbin case by the open hinged latch. (5)
-
(6)
Turn power switch to off ("O") before inserting or removing
the bobbin.
while
holding the bobbin down in the case until thread clicks into
place
.
Insert the bobbin case into the shuttle, so that the bobbin
case finger is aligned at 12 o'clock.
Inserting the Bobbin
13
EN
a