Singer 1304 START Instruction Manual - Page 32
Threading the Upper Thread
View all Singer 1304 START manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
EN Threading the Upper Thread This is a simple operation but it is important to carry out correctly as by not doing so several sewing problems could result. - Start by raising the needle to its highest point (1), and continue turning the handwheel counterclockwise until the needle just slightly begins to descend. Raise the presser foot to release the tension discs. (2) Note: For safety, it is strongly suggested you turn off the power before threading. - Place the thread and Spool pin felt (a) onto the spool pin. (3) - Draw thread from spool through the thread guide to the upper thread guide. (4) - Thread tension module by leading thread down right channel and up left channel. (5) During this process it is helpful to hold the thread between the spool and thread guide. - At the top of this movement pass thread from right to left through the slotted eye of the take-up lever and then downwards again. (6) - Now pass thread behind the thin wire needle clamp guide (7) and then down to the needle which should be threaded from front to back. - Pull about 6-8 inches of thread to the rear beyond the needle eye. Trim thread to length with built in thread cutter. (8) 15