Sony CPD-100GS Operating Instructions - Page 17
Damper Wires, Plug & Play, Displaying the monitor's, information, Power Saving Function
View all Sony CPD-100GS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Getting STteacrhtendical Features Displaying the monitor's information You can display the model name, serial number and year of manufacture using the monitor's INFORMATION OSD. Press and hold the MENU button for 5 seconds. The INFORMATION OSD appears. Example: MENU INFORMATION MODEL : CPD 100GS SER NO : 1234567 MANUFACTURED : 1997 The INFORMATION OSD includes the model name, serial number and manufactured year. The OSD automatically disappears after about 30 seconds. Power Saving Function This monitor has three modes of reduced power consumption. By sensing the absence of video signal coming from the computer, it reduces power consumption as follows. Power consumption mode 1 Normal operation Power Recovery consumption time ≤ 120 W - (CPD-200GS) ≤ 110 W (CPD-100GS) u indicator Green 2 Standby (1st mode) 3 Suspend (2nd mode) 4 Active-off (3rd mode) 5 Power-off ≤ 15 W ≤ 15 W ≤ 8 W 0 W Approx. 5 sec. Approx. 5 sec. Approx. 15 sec. - Green and orange alternate Green and orange alternate Orange Off Damper Wires When viewing a white background, very thin horizontal lines are visible on the screen as shown below. These lines are damper wires. The Trinitron tube has a vertically striped aperture grille inside. The aperture grille allows more light to pass through to the screen giving the Trinitron CRT more color and brightness. These damper wires are attached to the aperture grille to prevent vibration of the aperture grille and keep the screen image constantly stable. Damper wire Approx. 6cm (CPD-200GS only) Approx. 6cm EN F ES Plug & Play C This monitor complies with the DDC™1 and DDC2B Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification Data) to the data line. When a DDC2B host system is connected, the monitor automatically switches to the appropriate standard. DDC™ is a trademark of the Video Electronics Standard Association. Note If the video signal cable is not connected, the "NO INPUT SIGNAL" message (page 18) appears. After 30 seconds, the power saving function automatically puts the monitor into the active-off mode and the u indicator lights up orange. Once the horizontal and vertical sync signals are detected, the monitor automatically resumes its normal operation mode. 17