Sony DAV-LF10 Operating Instructions - Page 30

Step 5: Adjusting the Wireless System About the wireless system This wireless system adopts the Digital Infrared Audio Transmission system (page 103). The following diagram indicates the infrared transmission area (the range that the infrared rays can reach). Top view Infrared signal 10 10 IR transmitter Approx. 10m (33 ft) IR receiver After connecting the speakers, surround amplifier, IR transmitter, IR receiver, and the AC power cords (mains leads), adjust the wireless system for good transmission. "/1 POWER POWER/ON LINE indicator POWER POWER ON-LINE Side view IR transmitter Infrared signal 10 10 Approx. 10m (33 ft) IR receiver Notes • Do not install the IR receiver in a place exposed to direct sunlight or strong light such as an incandescent lamp. • Do not use the IR receiver that is not supplied with the system. 30GB 1 Press "/1 on the system and POWER on the surround amplifier. The system and surround amplifier turn on and the POWER/ON LINE indicator turns red. 2 Orient the IR transmitter and IR receiver to face each other. Adjust the position until the POWER/ON LINE indicator on the surround amplifier turns green. Tips • The IR transmitter is movable for easy reorientation. • You can change the setting of the surround speakers so that the designated sounds for the left and right speakers are reversed (page 96). Notes • Make sure that there is no obstruction such as a person or object between the IR transmitter and the IR receiver. Otherwise, the sound from the surround speakers may be interrupted. • If the POWER/ON LINE indicator on the surround amplifier turns red, the transmission is incomplete. Adjust the position of the IR transmitter and IR receiver until the POWER/ON LINE indicator turns green. • If the POWER/ON LINE indicator on the surround amplifier flashes in red, the IR receiver is receiving an infrared signal from another Sony's wireless product. Move the IR transmitter and/or the IR receiver so that the POWER/ON LINE indicator turns green.