Sony DCR-TRV130 Operating Instructions - Page 88

Types of trouble and their solutions Others Symptom Cause and/or Corrective Actions Digital program editing does not function. • The input selector on the VCR is not set correctly. c Set the selector correctly, and check the connection between the VCR and your camcorder (p. 65) • The camcorder is connected to DV equipment of other than Sony using the i.LINK cable (DV connecting cable). c Keep the connection, and follow the procedure on page 70. • Setting program on a blank portion of the tape is attempted. c Set the program again on a recorded portion (p. 73). • The syncronicity of your camcorder and the VCR is not adjusted. c Adjust the syncronicity of the VCR (p. 71). The Remote Commander supplied with your camcorder does not work. • COMMANDER is set to OFF in the menu settings. c Set it to ON. (p. 84) • Something is blocking the infrared rays. c Remove the obstacle. • The batteries are inserted in the battery holder with the + - polarities incorrectly matching the + - marks. c Insert the batteries with the correct polarity. (p. 108) • The batteries are dead. c Insert new ones. (p. 108) The melody or beep sounds for 5 seconds. • Moisture condensation has occurred. c Remove the cassette and leave your camcorder for at least 1 hour to acclimatize. (p. 97) • Some troubles have occurred in your camcorder. c Remove the cassette and insert it again, then operate your camcorder. No function works though the power is on. • Disconnect the power code of the AC power adaptor or remove the battery pack, then reconnect it in about 1 minute. Turn the power on (p. 12, 15). If the functions still do not work, press the RESET button using a sharppointed object. (If you press the RESET button, all the settings including the date and time return to the default.) (p. 105) While charging the battery pack, the CHG lamp does not light up. • The AC power adaptor is disconnected. c Connect it firmly. (p. 15) • Charging has been completed. • The battery pack is not installed properly. c Install the battery pack properly. (p. 11) • Something is wrong with the battery pack. c Contact your Sony dealer or local authorized Sony service facility. While charging the battery pack, the CHG lamp flashes. • Something is wrong with the battery pack. c Contact your Sony dealer or local authorized Sony service facility. You cannot charge the battery pack installed to your camcorder. • The POWER switch is not set to OFF (CHARGE). c Set it to OFF (CHARGE). The power goes off although the remaining battery time indicator indicates that the battery pack has 88 enough power to operate. • A deviation has occured in the remaining battery time. c Charge the battery pack fully again. (p. 11, 12)