Sony KDL-40WL135 Operating Instructions - Page 10

Getting Started 1. Installing the TV Preventing the TV from Toppling Over For details, see page 45. Preparation for Wall-Mounting This TV can be installed on a wall by using a WallMount Bracket (sold separately). Before mounting the TV on a wall, the Table-Top Stand must be removed from the TV. Follow the simple steps below to remove the Table-Top Stand: 1 Disconnect all the cables from the TV. 2 Start removing the screws behind the TV (See illustration below). Do not remove any other screws from the TV. 3 Secure the Mounting Hook to the rear of the TV. 4 Adjust the angle of the Mounting Hook. 5 When screws are removed, lift the TV off the stand. Make sure that you carry out this task with at least two people. Do not attempt to lift the TV by yourself. ~ • Do not remove the Table-Top Stand for any reason other than to wall-mount the TV. • When using an electric screwdriver, set the torque setting to approximately 2 N·m {20 kgf·cm}. • Be sure to store the removed screws and Table-Top Stand in a safe place until you are ready to reattach the Table-Top Stand. Keep the screws away from small children. • For bracket installation, refer to the supplied Installing the Wall-Mount Bracket and the instruction guide provided by the Wall-Mount Bracket model for your TV. Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV's weight. • For product protection and safety reasons, Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and that the wall-mounting of your TV is performed by a Sony dealer or licensed contractor. 10