Sony MZ-NHF800 Operating Instructions - Page 93
Messages, If the following messages flash in the display window on the recorder, check the chart
View all Sony MZ-NHF800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Messages If the following messages flash in the display window on the recorder, check the chart below. Message Meaning/Remedy AVLS NO • AVLS is set to "AVLS On" and so the volume cannot rise higher. VOLUME , Set AVLS to "AVLS Off" (page 70). OPERATION BLANKDISC • A disc with no recording on it is inserted. BUSY WAIT A MOMENT • The recorder is accessing disc information. • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). CANNOT EDIT • You selected, " : Set", " : Release", "Move", or "Erase" while recording. • You tried to erase the track mark at the beginning of the first track or group. • You tried to erase a track mark to combine tracks the recorder cannot combine (a track recorded in stereo and in mono, for example). • You tried to overwrite a track marks. • You tried to change a title that includes characters the recorder cannot edit. , Editing titles cannot be done if the title includes characters that cannot be input on the recorder. CANNOT OPERATE • You tried to press X or T MARK during synchro-recording. CANNOT RECORD OR PLAY • There is no audio data that can be played on the recorder. • The audio data or disc management file has been damaged. , Erase the whole disc (page 65) or perform the Format function (page 69). CANNOT SET • You tried to make the Time Mark setting during synchro-recording. • You selected "RECVolume" while the recorder is not in recording-pause. , Set "RECVolume" while the recorder is in recording-pause. • You tried to make the following settings while recording. - Disc Memory - Play mode - Recording mode - Recording level - Selection of " :REC" in menu DATA SAVE DC IN TOO HIGH • The recorder is writing information to the disc, such as the recorded data or editing information. , Wait until the message disappears from the display. • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. DISC FULL • Recording may not be done if the remaining recordable time on the disc is 48 seconds or less. , Replace the disc. 93