Home » Sony Manuals » Cordless Phones » Sony SPP-SS966 » Manual Viewer

Sony SPP-SS966 Operating Instructions - Page 15

If the battery becomes weak during a call, Making calls through the speakerphone

Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Notes • When you increase the sound volume, in some cases the back ground noise may be increased as well. You should adjust the volume accordingly. • If the handset beeps every second during a conversation and "OUT OF RANGE" appears on the display, move closer to the base phone; otherwise, the call will be disconnected after one minute. • While conversing with an outside caller via the base phone, you can't make a call with the handset and "BASEPHONE IN USE" appears on the display. If you press (TALK/ CALL WAITING/ FLASH), you will hear a busy tone. • When the operation duration exceeds 9:59'59, the display counts from 0:00'00 again. If the battery becomes weak during a call The handset will beep every three seconds five times and i and "BATTERY LOW" appears on the display. Finish your call and charge the battery pack. For optimum performance, charge the battery for a full 12 hours. Note that during the first 10 - 15 minutes of charging, the phone will be inactive, i.e., unable to make or receive a call. After this initial 10 - 15 minutes, you may be able to use the phone, but the battery duration will be very short; thus it is recommended that you fully charge the battery before the next usage. Basics Making calls through the speakerphone Press (SPEAKERPHONE) on the base phone. "SPEAKERPHONE" appears on the display and the display also shows the operation duration in hours, minutes and seconds. LINE lamp (SPEAKERPHONE) The LINE lamp lights up. Dial the phone number. To adjust the speaker volume, slide the SPEAKER VOLUME control. When you're done talking, press (SPEAKERPHONE) again. SPEAKER VOLUME control Notes • While conversing with an outside caller via the handset, the display on the base phone shows "HANDSET IN USE" and you can't make a call through the speakerphone. If you press (SPEAKERPHONE), you will hear a busy tone. • When the operation duration exceeds 9:59'59, the display counts from 0:00'00 again. continued Basics 15US

Section	Page
Table of contents	5
Getting Started	6
Read this first	6
Checking the package contents	7
Setting up the base phone	8
Preparing the battery pack	11
Entering your area code	13
Basics	14
Making calls	14
Redialing	16
Receiving calls	17
Telephone Features	19
One-touch dialing	19
Storing phone numbers	19
Making calls with one-touch dialing	20
Speed dialing	21
Storing phone numbers	21
Making calls with speed dialing	22
Phone Directory	23
Storing phone numbers and names	23
Changing a stored name and/or phone number	24
Erasing a memory location	25
Making calls from the Phone Directory	26
Switching the phones during a call	27
To switch from the base phone to the handset	27
To switch from the handset to the base phone	27
Talking between the phones (Intercom)	28
To talk from the handset to the base phone	28
To talk from the base phone to the handset	28
Voice paging	29
To page with voice	29
Transferring a call	30
To transfer from the base phone to the handset	30
To transfer from the handset to the base phone	31
Caller ID Features	32
Understanding the Caller ID service	32
When you receive a call	32
Looking at the Caller ID list	33
Viewing the Caller ID list	33
Erasing data from the Caller ID list	34
Using the Caller ID list	36
Calling back a number from the Caller ID list	36
Storing a number of the Caller ID list into the Phone Directory	37
To change the number of digits of the phone number	38
Using “Caller ID with call waiting” service	39
Additional Information	40
Mounting the base phone on a wall	40
Notes on power sources	41
Maintenance	41
Troubleshooting	42
Specifications	45
Index	46
Índice	51
Preparativos	52
Lea esto en primer lugar	52
Comprobación del contenido del paquete	53
Instalación del teléfono base	54
Preparación de la batería	57
Introducción del prefijo	59
Operaciones básicas	60
Realización de llamadas	60
Repetición de la marcación	62
Recepción de llamadas	63
Funciones del teléfono	65
Marcación con una sola pulsación	65
Almacenamiento de números telefónicos	65
Realización de llamadas mediante la marcación con una sola pulsación	66
Marcación abreviada	67
Almacenamiento de números de teléfono	67
Realización de llamadas con marcación abreviada	68
Directorio telefónico	69
Almacenamiento de números de teléfono y nombres	69
Cambio de un nombre y/o número almacenado	70
Borrado de posiciones de memoria	71
Realización de llamadas desde el directorio telefónico n	72
Cambio de teléfonos durante una llamada	73
Para cambiar del teléfono base al microteléfono	73
Para cambiar del microteléfono al teléfono base	73
Conversación entre el microteléfono y el teléfono base (Intercomunicación)	74
Para conversar del microteléfono al teléfono base	74
Para conversar del teléfono base al microteléfono	74
Buscapersonas vocal	75
Para buscar personas vocalmente	75
Transferencia de una llamada	76
Para transferir del teléfono base al microteléfono	76
Para transferir del microteléfono al teléfono base	77
Funciones de ID de llamada	78
El servicio ID de llamada	78
Al recibir una llamada	78
La lista de ID de llamada	79
Visualización de la lista de ID de llamada	79
Borrado de datos de la lista de ID de llamada	80
Uso de la lista de ID de llamada	82
Marcación de un número de la lista de ID de llamada	82
Almacenamiento de un número de la lista de ID de llamada en el directorio telefónico	83
Para cambiar el número de dígitos del número de teléfono	84
Uso del servicio “ID de llamada con llamada en espera”	85
Información adicional	86
Montaje del teléfono base en una pared	86
Notas sobre fuentes de alimentación	87
Mantenimiento	87
Solución de problemas	88
Especificaciones	91