Sony STRDG720 Operating Instructions - Page 89

If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 27). However, note that all memorized settings will be reset to their initial settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. Reference sections for clearing the receiver's memory To clear All memorized settings Customized sound fields See page 27 page 56 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 95 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U, CA1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 95 W + 95 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 105 W + 105 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 140 W/ch 1)Measured under the following conditions: Area code U, CA Power requirements 120 V AC, 60 Hz 2)Reference power output for front, center, surround and surround back speakers. Depending on the sound field settings and the source, there may be no sound output. Frequency response Analog 10 Hz - 70 kHz +0.5/-2 dB (with sound field and equalizer bypassed) Additional Information continued 89US