Sony XAV-9000ES Operating Instructions - Page 11

*1 Not supplied *2 Speaker impedance: 4 Ω to 8 Ω × 4 *3 RCA pin cord (not supplied) *4 Power amplifier (not supplied) *5 Subwoofer (not supplied) *6 Depending on the type of car, use an adaptor for a steering wheel remote control (not supplied). For details on using the steering wheel remote control, see "Using the steering wheel remote control" (page 13). *7 Depending on the type of car, use an adaptor (not supplied) if the antenna (aerial) connector does not fit. *8 Whether in use or not, route the microphone input cord so it does not interfere with driving operations. Secure the cord with a clamp, etc., if it is installed around your feet. *9 For details on installing the microphone, see "Installing the microphone" (page 12). *10 For more information on how to install the SiriusXM Connect Vehicle Tuner, consult the installation guide supplied with the tuner. *11 When connecting the iDataLink Maestro module (not supplied), do not connect any device to the REMOTE IN terminal (blue). Likewise, when connecting a device to the REMOTE IN terminal (blue), do not connect the iDataLink Maestro module (not supplied) to the IDATA LINK I/F terminal (black). *12 Use the connection cable supplied with the iDataLink Maestro module (not supplied). *13 Connect when using Apple CarPlay with a wireless connection. *14 Front speaker/Front tweeter If [Speaker Configuration] in [Sound] is set to [Front & Rear], connect the front speaker. If [Speaker Configuration] in [Sound] is set to [Front 2-way], connect the front tweeter. *15 Rear speaker/Front woofer If [Speaker Configuration] in [Sound] is set to [Front & Rear], connect the rear speaker. If [Speaker Configuration] in [Sound] is set to [Front 2-way], connect the front woofer. Making connections  To a common ground (earth) point First connect the black ground (earth) lead then connect the yellow and red power supply leads.  To the +12 V power terminal which is energized at all times Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the +12 V power terminal which is energized when the ignition switch is set to the accessory position Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the power antenna (aerial) control lead or the power supply lead of the antenna (aerial) booster It is not necessary to connect this lead if there is no power antenna (aerial) or antenna (aerial) booster, or with a manually-operated telescopic antenna (aerial). To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers and a power antenna (aerial). Connecting any other system may damage the unit. Note It will take about 10 seconds to shut down the output of REM OUT after the unit is turned off.  To a car's illumination signal Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the parking brake switch lead The mounting position of the parking brake switch lead depends on your car. Be sure to connect the parking brake lead (light green) of the power supply leads  to the parking brake switch lead. Parking brake switch lead Hand brake type Foot brake type  To the +12 V power terminal of the car's rear lamp lead (only when connecting the rear view camera)  To a car's speed pulse signal When using Apple CarPlay with a wireless connection, it is necessary to connect to keep the accurate location of your car. The mounting position of the speed pulse output lead depends on your car.  To an interruption signal (+3.3 V to +12 V) to display the picture from CAMERA IN 1 and CAMERA IN 2 Note REVERSE IN, EXT IN 1, and EXT IN 2 interrupt detections have the following priority levels. REVERSE IN always has priority; if both EXT IN 1 and EXT IN 2 occur at the same time, EXT IN 1 has higher priority. 11EN