Sony XAV-9000ES Operating Instructions - Page 12
Camera Connection, Memory hold connection, Installing the microphone
View all Sony XAV-9000ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Camera Connection Installation of cameras (not supplied) is required before use. Connect the camera power cord (lead) to the accessory power terminal. When connecting the iDataLink Maestro module (not supplied) and you are using the Backup Camera Dynamic Guidelines function, adjust the guideline. Installing the microphone To capture your voice during handsfree calling, you need to install the microphone . 2.0 m (6 1/2 feet) behind the car 0.5 m (1 3/4 feet) behind the car Memory hold connection When the yellow power supply lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Speaker connection • Before connecting the speakers, turn the unit off. • Use speakers with an impedance of 4 Ω to 8 Ω, and with adequate power handling capacities to avoid damage. • Set [Speaker Configuration] in [Sound] to [Front & Rear] or [Front 2-way] depending on your speaker system. • When connecting a speaker system for the Front 2-way mode, do not set [Speaker Configuration] in [Sound] to [Front & Rear]. This may cause damage to the speakers. • When connecting the iDataLink Maestro module (not supplied) and you are using the factory amplifier, set [Speaker Configuration] in [Sound] to [Front & Rear]. Clip (not supplied) Cautions • It is extremely dangerous if the cord becomes wound around the steering column or gearstick. Be sure to keep it and other parts from interfering with your driving operations. • If airbags or any other shock-absorbing equipment are in your car, contact the store where you purchased this unit or the car dealer before installation. Notes • When mounting on the dashboard, remove the visor clip carefully from the microphone , then attach the flatmount base to the microphone . • Before attaching the double-sided tape , clean the surface of the dashboard with a dry cloth. Installing the GPS antenna (aerial) • Choose a location where no obstacle blocks GPS satellite reception so as to achieve the best reception. • Make sure the GPS antenna (aerial) does not interfere with the operation of car equipment. • Some types of front windshields (windscreens) block GPS satellite radio waves. Make sure the signal reception is not blocked. • When using Apple CarPlay with a wireless connection, make sure the GPS antenna (aerial) is connected. 12EN