Sony XAV-AX150 Operating Instructions - Page 25
Connection/Installation, Cautions, Parts List for Installation
View all Sony XAV-AX150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connection/Installation Cautions • Do not install this unit in a car that has no ACC position. The display of the unit does not turn off even after turning the ignition off, and this causes battery drain. • Run all ground (earth) leads to a common ground (earth) point. • Do not get the leads trapped under a screw or caught in moving parts (e.g., seat railing). • Before making connections, turn the car ignition off to avoid short circuits. • Connect the yellow and red power supply leads only after all other leads have been connected. • Be sure to insulate any loose unconnected leads with electrical tape for safety. Precautions • Choose the installation location carefully so that the unit will not interfere with normal driving operations. • Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. • Use only the supplied mounting hardware for a safe and secure installation. Note on the power supply lead (yellow) When connecting this unit in combination with other stereo components, the amperage rating of the car circuit to which the unit is connected must be higher than the sum of each component's fuse amperage rating. Mounting angle adjustment Adjust the mounting angle to less than 30°. Parts List for Installation Power supply leads (1) Mounting screws (5 × max. 9 mm (7/32 × max. 3/8 in)) (4) Microphone (1) Flat-mount base (1) Double-sided tape (1) Connection cable RC-SR1 (1) • This parts list does not include all the package contents. • Use the connection cable RC-SR1 for the steering wheel remote control as necessary. For details, see "Using the wired remote control" (page 28). 25GB