Sony XAV-AX150 Operating Instructions - Page 27
Memory hold connection, Speaker connection, Making connections, Installing the microphone
View all Sony XAV-AX150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
*1 Not supplied *2 Speaker impedance: 4 Ω - 8 Ω × 4 *3 RCA pin cord (not supplied) *4 Depending on the type of car, use an adaptor for a wired remote control (not supplied). For details on using the wired remote control, see "Using the wired remote control" (page 28). When using the steering wheel remote control, use the connection cable RC-SR1 as necessary. *5 Depending on the type of car, use an adaptor (not supplied) if the antenna (aerial) connector does not fit. *6 Whether in use or not, route the microphone input cord so it does not interfere with driving operations. Secure the cord with a clamp, etc., if it is installed around your feet. *7 For details on installing the microphone, see "Installing the microphone" (page 27). *8 Do not use a USB extension cable. Making connections To a common ground (earth) point First connect the black ground (earth) lead then connect the yellow and red power supply leads. To the +12 V power terminal which is energized at all times Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the +12 V power terminal which is energized when the ignition switch is set to the accessory position Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the power antenna (aerial) control lead or the power supply lead of the antenna (aerial) booster It is not necessary to connect this lead if there is no power antenna (aerial) or antenna (aerial) booster, or with a manually-operated telescopic antenna (aerial). To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers and a power antenna (aerial). Connecting any other system may damage the unit. Note It will take about 10 seconds to shut down the output of REM OUT after the unit is turned off. To a car's illumination signal Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the parking brake switch cord The mounting position of the parking brake switch cord depends on your car. Be sure to connect the parking brake lead (light green) of the power supply leads to the parking brake switch lead. Parking brake switch cord Hand brake type Foot brake type To the +12 V power terminal of the car's rear lamp lead (only when connecting the rear view camera) Memory hold connection When the yellow power supply lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Speaker connection • Before connecting the speakers, turn the unit off. • Use speakers with an impedance of 4 Ω to 8 Ω and with adequate power handling capacities to avoid damage. Installing the microphone To capture your voice during handsfree calling, you need to install the microphone . Clip (not supplied) 27GB