Sony XAV-AX150 Operating Instructions - Page 28

Cautions • It is extremely dangerous if the cord becomes wound around the steering column or gearstick. Be sure to keep it and other parts from interfering with your driving operations. • If airbags or any other shock-absorbing equipment are in your car, contact the store where you purchased this unit or the car dealer before installation. Notes • When mounting on the dashboard, remove the visor clip carefully from the microphone , then attach the flatmount base  to the microphone . • Before attaching the double-sided tape , clean the surface of the dashboard with a dry cloth. Using the wired remote control When using the steering wheel remote control Installation of the connection cable RC-SR1  is required before use. 1 To enable the steering wheel remote control, select [General]  [Steering Control]  [Custom]  [ ] to make the registration (page 16). When the registration is complete, the steering wheel remote control becomes available. Notes on installing the connection cable RC-SR1  • Refer to the support site on the back cover for details then connect each lead properly to the appropriate leads. Making an improper connection may damage the unit. • Consulting the dealer or an experienced technician for help is recommended. When using the wired remote control 1 To enable the wired remote control, set [Steering Control] in [General] to [Preset] (page 16). Using the rear view camera Installation of the rear view camera (not supplied) is required before use. The picture from a rear view camera connected to the CAMERA IN terminal is displayed when:  the back lamp of your car lights up (or the shift lever is set to the R (reverse) position).  you press HOME, then touch [Rear Camera]. Installation Mounting the unit in a Japanese car You may not be able to install this unit in some Japanese cars. In such a case, consult your Sony dealer.  To the dashboard/center console Bracket Bracket Parts supplied with  your car When mounting this unit to the preinstalled brackets of your car, use the mounting screws  in the appropriate screw holes based on your car: T for TOYOTA and N for NISSAN. Note To prevent a malfunction, install only with the mounting screws . Fuse replacement When replacing the fuse, be sure to Fuse (10 A) use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. 28GB