Symphonic SC1304 Owner's Manual - Page 11

CHANNEL SET UP Make sure ... • The unit must be turned on. AUTO CHANNEL PROGRAMMING As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory. 1 Select "CHANNEL SET UP" Press [MENU]. Use [PLAY/K] or [STOP/L] to point to "CHANNEL SET UP", then press [F.FWD/ B]. - M E N U - TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH 2 Begin channel scanning Use [PLAY/K] or [STOP/L] to point to "AUTO CH PROGRAMMING", then press [F.FWD/ B]. The tuner scans and memorizes all the active channels in your area. - CHANNEL SET UP - ADD / DELETE CH (CATV) B AUTO CH PROGRAMMING 3 After scanning The tuner stops on the lowest memorized channel. NOTES: • If there is no TV signal input, "NO TV SIGNALS" will appear on the display after the completion of channel scanning. • The unit may recognize TV channels to be CATV channels if reception condition is poor. In this case, check the antenna connection and try "AUTO CH PROGRAMMING" again when reception conditions are better. • Auto channel programming is NOT necessary when connected to a cable box or satellite box. Just select the channel for the cable box or satellite input (ex. CH3 or CH4) on the unit, then select your desired channel on the cable box or satellite box. ADDING/DELETING CHANNELS The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.) 2 Select "ADD / DELETE CH" Use [PLAY/K] or [STOP/L] to point to "ADD / DELETE CH", then press [F.FWD/ B]. - CHANNEL SET UP - B ADD / DELETE CH (CATV) AUTO CH PROGRAMMING 3 Enter the desired channel number Use [PLAY/K] or [STOP/L] or the Number buttons until your desired channel number appears. 08 (You can also use [CHANNEL K/L] to enter it.) • You must precede single-digit ADD / DELETE channel numbers with a zero (Example: 02 ... 09). • When selecting cable channels which are higher than 99, press [+100] first, then enter the last two digits. (Example: to select channel 125, first press [+100] then press [2] and [5].) 4 Delete (or add) it from (or into) memory Use [REW/s] or [F.FWD/B] then the channel number turned to red. The channel is deleted from memory. If the channel number turned to blue, the channel is added into memory. • To delete another channel, repeat steps 3 to 4. • If you use [REW/s] or [F.FWD/ B] again, the channel is memorized again. Added channel : Light blue Deleted channel : Light red 5 Exit the channel setup mode Press [MENU] to returns to TV mode. NOTE: • To confirm that channel(s) has been deleted or added, use [CHANNEL K/L]. 1 Select "CHANNEL SET UP" Press [MENU]. Use [PLAY/K] or [STOP/L] to point to "CHANNEL SET UP", then press [F.FWD/ B]. - M E N U - TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH - 11 - EN