Symphonic WF803 Owner's Manual - Page 13

HOOKUPS CAUTION: ¡Be sure to turn off the DVD/VCR COMBINATION UNIT and equipment to be connected. ¡Read through the operation manual for the equipment to be connected. ¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables. ¡Be sure to keep the DVD/VCR COMBINATION UNIT connection cables separate from the TV antenna cable when you install the DVD/VCR COMBINATION UNIT, because it may cause electrical interference when you are watching television programs. CONNECTING TO A TV WITHOUT A/V TERMINALS 1. Disconnect the AC power cord of the TV from the AC outlet. 2. Disconnect the antenna or cable from the TV. 3. Connect the antenna or cable to the ANT-IN jack of the DVD/VCR COMBINATION UNIT. 4. Connect the DVD/VCR COMBINATION UNIT to the TV using the RF cable. 5. Plug the AC power cords of the DVD/VCR COM- BINATION UNIT and TV into the AC outlets. [VHF/UHF [Indoor antenna] combination antenna] OR [Cable box or satellite box] OR From Cable or Satellite Company IN OUT [Back of the DVD/VCR] [Back of the UHF/VHF combination TV] DVD/VCR AUDIO OUT VCR ANT-IN L RF cable (supplied) UHF/VHF R ANT-OUT VIDEO OUT AUDIO IN VIDEO IN RF OUTPUT CHANNEL for DVD/VCR 1. Connect the DVD/VCR COMBINATION UNIT to a TV using RF cable (see above steps). 2. Select channel 3 on your TV. 3. Press PLAY. ¡If noise appears, change the RF output channel of the DVD/VCR COMBINATION UNIT to channel 4 by pressing PLAY on the VCR for 3 seconds during playback. ¡There is case that the RF output channel does not change by situation (For example, when you adjust tracking using CHANNEL ( ) ). In this case, stop the playback, and start the playback again. After that, press PLAY on the VCR for 3 seconds. ¡If there is a power failure or the DVD/VCR COMBINATION UNIT is unplugged for more than 30 seconds, the RF output channel setting will return to CH3. Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical. CONNECTING TO A TV WITH A/V TERMINALS Antenna/Cable signal DVD/VCR AUDIO OUT ANT-IN L VCR A/V-compatible or wide screen TV To ANT. IN of TV R ANT-OUT VIDEO OUT AUDIO IN VIDEO IN To VIDEO INPUT jack To VIDEO OUT jack To Right (red) and Left (white) To AUDIO INPUT jacks To AUDIO OUT jacks DVD S-VIDEO COMPONENT AUDIO OUT VIDEO OUT OUT Y DIGITAL AUDIO OUT Cb L COAXIAL Cr R [Fig. 1] Notes ¡Connect the DVD/VCR COMBINATION UNIT directly to a TV. If the A/V cables are connected into a VCR first, picture may be distorted due to the copy protection system. - 13 - EN 1L25