TEAC DM-4800 DM-4800 Owner's Manual - Page 92
Snapshots, Snapshot library management
View all TEAC DM-4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
5 - Channel modules : Snapshots Snapshots Mixer settings can be stored in a library and recalled, either manually from the control surface, or remotely through MIDI Program Change messages. Snapshots contain the following data: • EQ parameters • Dynamics parameters • Fader and mute settings • Groupings and group settings • Aux send settings (level, status, pan-balance) • Pan and balance settings, image, mono switch • Surround parameters and pan mode • Link settings • Digital trim • Phase switch Snapshot library management The snapshot library screen is accessed through the LIBRARY key: Figure 5.32: Snapshot library If the snapshot library is not shown, use the POD 1 encoder and key to select the snapshot library, as shown in Figure 2.35, Library selection pull-up menu. • Digital delay time and point • Buss, stereo and direct assignments or surround assignments • Effect parameters • routing settings These are all stored together with a transition time, which allows faders to move gradually from one position to the new position. In addition, there are also some "safety switches" which prevent certain parameters being re-set when the snapshot is recalled (for example, it might be tedious to have all signals re-routed when a new snapshot is recalled). Each snapshot can, of course, be named for easy recognition later. As the wheel or POD 4 encoder is used to scroll though the list of stored snapshots in the current bank or preset list, the representation of the current fader layer in that snapshot is shown on the right of the screen (the current settings are provided for reference on the left of the screen). The RECALL SAFE list on the lower left of the screen allows various parameters to remain unchanged on recall when a snapshot is recalled. These are: • I/O routing and buss assignment settings • Mute and fader group assignments • Current effect settings • The OTHER parameters (i.e. those not listed above, allowing you to change only grouping, for example, while keeping fader settings, EQ settings and routing). • Use the POD 3 switch or the cursor at the RECALL on-screen button to recall the currently selected library entry. A popup message appears briefly. 92 TASCAM DM-4800 User's Manual