TEAC DR-H358i Owners Manual - Page 11

Remote Control Unit D Digital audio output terminal Digital audio from DVD-Video, CD and video CD is output from this terminal. Connect an amplifiers including a decoder, or digital audio devices such as CD recorders, etc. to this jack using commercially-available optical digital audio cable (TOS). < Select "ALL" or "PCM only" in the DIGITAL AUDIO SETUP (page 38). E iPod port Connect the iPod dock to this port. The provided Remote Control Unit allows the unit to be operated from a distance. When operating the remote control unit, point it towards the remote sensor on the front panel of the unit. < Even if the remote control unit is operated within the effective range (5m), remote control operation may be impossible if there are any obstacles between the unit and the remote control. < If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other products may operate incorrectly. F AUX 1/LINE OUT jacks Analog 2-channel audio signal is input or output from these jacks. Connect a cassette tape deck etc. to these jacks using commercially-available RCA cables. Battery Installation Make sure to connect: white plug q white jack (L: left channel) red plug q red jack (R: right channel) G Power cord receptacle After all other connections have been made, insert the supplied AC power cord into this receptacle, then connect the other end of the power cord into the wall socket. Ensure that your AC voltage corresponds to the voltage marked on the rear panel of the unit. Consult a qualified electrician if you are in doubt. 1. Remove the battery compartment cover. 2. Insert two "AAA" (R03 or UM-4) dry batteries. Make sure that the batteries are inserted with their positive "+" and negative "_" poles positioned correctly. 3. Close the cover. < In order to avoid the risk of electric shock, fire, and so on, only use the supplied power cord. < If you are not going to use the unit for some time, disconnect the power cord from the wall socket. Battery Replacement If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones. < For information about the collection of batteries, please contact your local municipality, your waste disposal service or the place where you purchased them. Precautions concerning batteries < Be sure to insert the batteries with correct positive "+" and negative "_" polarities. < Use batteries of the same type. Never use different types of batteries together. < Either rechargeable or non-rechargeable batteries can be used. Refer to the precautions on their labels. < When the remote control unit is not to be used for a long time (more than a month), remove the battery from the remote control unit to prevent it from leaking. < If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones. < Do not use any batteries other than those specified. Do not mix new batteries with old ones. < Do not heat or disassemble batteries. Never throw them in fire or water. < Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short circuit, leak or explode. < Never recharge a battery unless it is confirmed to be a rechargeable type. 11