TEAC NT-505 Owners Manual English Francais Espanol - Page 25
Playing back music on a computer, Installing the driver, About transmission mode
View all TEAC NT-505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Playing back music on a computer Installing the driver About transmission mode This unit can be connected with computers running the following This unit can transfer data using Isochronous or Bulk Pet mode. operating systems. Operation with other operating systems is not The sampling frequencies that can be transmitted are 44.1, 48, 88.2, guaranteed (as of November, 2017). 96, 176.4, 192, 352.8, 384, 705.6 and 768 kHz. EN When properly connected, you will be able to select "TEAC USB When using Mac The driver works with the following versions. OS X Lion (10.7) OS X Mountain Lion (10.8) AUDIO DEVICE" as an audio output from the computer OS. oo During data transfer, the audio data sent from the computer will be processed using this unit's clock, enabling the amount of jitter that occurs during data transmission to be reduced. OS X Mavericks (10.9) OS X Yosemite (10.10) OS X El Capitan (10.11) macOS Sierra (10.12) macOS High Sierra (10.13) Downloading playback application TEAC HR Audio Player This unit will run with the standard OS driver, so there is no need to install a special driver. A dedicated driver must be installed on the computer, however, to You can download Mac and Windows versions of our free TEAC HR Audio Player application that supports playback of DSD files from the TEAC Global Site (http://teac-global.com/). use Bulk Pet. When using Windows The driver works with the following versions. Windows 7 (32/64-bit) Windows 8 (32/64-bit) Windows 8.1 (32/64-bit) Windows 10 (32/64-bit) Installing the driver on the computer In order to play audio files stored on a computer through this unit, you must install a dedicated driver on that computer beforehand. Download the dedicated driver from the TEAC Global Site. TEAC Global Site http://www.teac-global.com/ TEAC HR Audio Player setting note To play 22.5MHz DSD recordings with TEAC HR Audio Player, open the Configure window and set the "Decode mode" to "DSD Native." To play formats other than 22.5MHz DSD, you can set this to either "DSD over PCM" or "DSD Native" as you like. For details, see "Selecting DSD decoding mode" in the TEAC HR Audio Player Owner's Manual. ATTENTION Install the dedicated driver before connecting the unit with the computer by USB. If you connect this unit with a computer before installing the driver, it will not work properly. oo For instructions about driver installation procedures, access the Downloads page from the TEAC Global site (http://teac-global. com/). oo Depending on the combination of hardware and software, proper operation might not be possible even with the above operating systems. 25