TP-Link T1600G-18TSTL-SG2216 T1600G-18TSUN V1 CLI Reference Guide Guide - Page 220
Parameter, Command Mode, Privilege Requirement, User Guidelines, Example
View all TP-Link T1600G-18TSTL-SG2216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
Parameter acl-id -- The desired Standard-IP ACL for configuration. rule-id -- The rule ID. deny -- The operation to discard packets. permit --The operation to forward packets. It is the default value. dscp-value -- Specify the dscp value, ranging from 0 to 63. flow-label-value -- The IPv6 flow label, which ranges from 0-0xfffff. source-ip -- The source IP address contained in the rule. source-ip-mask -- The source IP address mask. It is required if you typed the source IP address. destination-ip -- The destination IP address contained in the rule. destination-ip-mask -- The destination IP address mask. It is required if you typed the destination IP address. (Note: T1600G-18TS doesn't support s-port and d-port setting.) s-port -- The source port number. d-port -- The destination port number. Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines Before binding an IPv6 ACL to a VLAN or interface, you should configure the SDM template as "enterpriseV6" and save your configurations. For more information about SDM configuration, please refer to sdm prefer. Example Create an IPv6 ACL whose ID is 3600, and add Rule 10 for it. In the rule, the source IP address is 3001::1, the source IP address mask is 255.255.255.0, and the packets match this rule will be forwarded by the switch: T1600G-52TS(config)# access-list create 3600 T1600G-52TS(config)# access-list ipv6 3600 rule 10 permit sip 3001::1 sip-mask ffff:ffff:ff00:00ff 203