Toshiba 36A40 Owners Manual - Page 33
To block channels, To restore channels, Unblocking programs temporarily, BLOCK CHANNEL function
View all Toshiba 36A40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Set up Preparation Reference Section Advanced Operation Basic Operation Unblocking programs temporarily 1 If you try to watch a TV program that exceeds the rating limits you set, the TV will enter into the program block mode. THIS PROGRAM HAS BEEN BLOCKED! TV-PG L V EXCEEDS SET LIMITS PUSH MUTE TO ENTER PIN CABLE 4 2 If you want to watch the blocked program temporarily, press MUTE. Press the Number buttons (0-9) to enter the 4-digit code you have stored. If the number is correct, the block mode will be released. After 1 second, normal picture will appear. BLOCKING IS ACTIVE PLEASE ENTER PIN CODE TO TEMPORARILY UN-BLOCK ~~~- SELECT[0-9] END[EXIT] All blocking is disabled until the TV is turned off. It will be enabled when the power is reapplied. If a wrong pin code is entered, this message appears. Enter the correct code again. INCORRECT PIN CODE PLEASE ENTER PIN CODE TO TEMPORARILY UN-BLOCK ~~~~ SELECT[0-9] END[EXIT] BLOCK CHANNEL function With the CHANNEL BLOCK function, you can block specific channels. The TV will not be able to tune these channels with the CHANNEL s/t buttons or Channel Number buttons, unless you clear the setting. This TV has 8 memory spaces total, 4 for TV mode and 4 for CABLE mode. To block channels 1 Select a channel you want to block. 2 Select "BLOCK CHANNEL" in the V-CHIP CONTROL menu by pressing t or s. ENABLE BLOCKING : [Y]N SET RATING SET BLOCKING OPTIONS NEW PIN CODE BLOCK CHANNEL MOVE[t s ] SELECT[T S ] 3 Press T or S to display the BLOCK CHANNEL menu. BLOCK CHANNEL [SET]CLEAR 0 0 0 0 SELECT[T S ] SET[t s ] END[EXIT] 4 Press T or S to select "SET", then press t or s until the channel number to be blocked ("2" in this example) replaces "0" on the display. BLOCK CHANNEL [SET]CLEAR 0 0 0 2 SELECT[T S ] SET[t s ] END[EXIT] 5 Repeat steps 1 to 4 for other channels. 6 Select another channel before turning off the TV. To restore channels 1 Select "CLEAR" following the above steps 2 to 4. 2 Press t or s until "0" replaces the channel numbers. BLOCK CHANNEL SET [CLEAR] 15 10 6 2 SELECT[T S ] CLEAR[t s ] END[EXIT] 0 0 0 0 3 Press EXIT to erase the display. 33