Toshiba TLP710 Owners Manual - Page 13
following.
UPC - 022265950128
View all Toshiba TLP710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installing Batteries Install batteries to enable remote control operation. Open the cover. Install the batteries. Remote Control Operation LLI Ca Instruction to use the remote control. LU 0 ULLI CCI Face the infrared sensor and press a remote control button. Front side Rear side 5° 5° 000 15° 15° 000 Make sure that the +1- polarities match the illustration in the compartment. Attach the cover. Rear side of the Document imaging camera model 4dgNIM 15° 15° 000 O Distance : within about 5 meters from the front of the remote sensor. Angle : within about 15° of the remote sensor in every direction. • The remote control may not operate when there is sunlight or other strong light such as a fluorescent lamp shining on the remote sensor. Using batteries incorrectly can cause them to leak or burst. Strictly observe the following. • Install the batteries with their + and - ends facing correctly. • Do not charge, heat, disassemble, or short the batteries or throw them into a fire. • Do not leave exhausted batteries in the remote control. • Do not mix different types or batteries or new and old batteries. • When you will not be using the remote control for a prolonged period, take the batteries out of the remote control. • When the remote control stops working or only works from very close distance, replace all the batteries with new ones. • When replacing the batteries, use a more longer life alkaline batteries. • If a battery leaks, carefully wipe off any residue inside the battery case before loading new batteries. • Keep strong light off the remote sensor. • Operate the remote control from a position where the remote sensor is visible. • Do not drop the remote control or otherwise jolt it. • Keep the remote control out of locations with excessively high temperature or humidity. • Do not get water on the remote control or place wet objects on it. • Do not disassemble the remote control. • Under unusual circumstances the remote control may not operate well due to the location being used or the surroundings. At such times, turn the remote control sensor face to the projector unit again and retry the remote control operation. 12