Troy-Bilt Storm 2620 Operation Manual - Page 13

Controls and Features 4 Chute Assembly Chute Clean Out Tool Drive Control Shift Lever † Headlight † 4-Way/2-Way Chute Directional Control † Auger Control Heated Grips † Steering Trigger Control † Standard Chute Directional Control † Augers Skid Shoe † If Equipped Figure 4-1 Snow thrower controls and features are described below and illustrated in Fig. 4-1. Shift Lever The shift lever is located in the right side of the handle panel and is used to determine ground speed and direction of travel. Forward There are six forward (F) speeds. Position one (1) is the slowest and position six (6) is the fastest. Skid Shoes Position the skid shoes based on surface conditions. Adjust upward for hard-packed snow. Adjust downward when operating on gravel or crushed rock surfaces. See Set-Up & Assembly section. Skid shoe styles and appearance vary by model. Augers When engaged, the augers rotate and draw snow into the auger housing. Reverse There are two reverse (R) speeds. One (1) is the slower and two (2) is the faster. Chute Assembly Snow drawn into the auger housing is discharged out the chute assembly. Chute assembly styles and appearance vary by model. Headlight (if so equipped) The headlight is located on top of the handle panel and is automatically turned on when the engine is started. 13